Bodysuit Penthouse All the Way Teddy Black S/M/L

Bodysuit Penthouse All the Way Teddy Black S/M/L 🌑

The All the Way teddy by Penthouse is a black bodysuit, knitted seamlessly and close-fitting, with half-length sleeves to the elbow and a wide, round neckline at the front. Bodice and sleeves are made of mesh with a floral pattern through which the skin shows. From the waist down the knit becomes dense and continues like that into the crotch. At the back it is cut out in a deep curve to about the middle, and below the bodysuit runs into a thong cut that leaves the bottom bare. It stands under lingerie for women, with lingerie and under sextoys for women; what else comes from this brand is shown by the brand world of Penthouse.

✨ At a glance

• 🧵 Material: 80 % polyester, 20 % elastane
• 🎨 Colour: Black
• 🪜 Size: S/M/L
• 📏 Fits: cup B/C, bust 82 to 98 cm, hips 88 to 102 cm
• ✂️ Cut: round neckline, half-length sleeves, deep back cut-out
• ✅ Knit: floral mesh on the bodice, dense from the waist
• ✅ Back: thong cut

❓ FAQ

Can you wear it as a top?

Yes, with a skirt or jeans it looks like a tight top with a lace bodice, and thanks to the dense midriff nothing shows underneath. If you want to show less on the upper body, add a blazer or an open blouse over it.

How do you put it on?

Step in with your legs, pull it up over hips and stomach and slip into the sleeves last. Take off rings and bracelets beforehand so that no stitch catches.

How do you find out whether S/M/L fits you?

Measure bust and hips: the bust loosely at the fullest point, the hips at the widest, and compare both values with the ranges. The knit with one fifth elastane gives in length and width, so the bodysuit then sits close to the body.

Which bra do you wear with it?

Ideally none: any back band would lie exposed in the deep curve at the back, and straps and cups would show through the mesh at the front.

How do you care for it?

It is gentlest by hand in cool water with a little mild detergent, separate from light-coloured laundry. Afterwards just press the water out without wringing and let it dry lying flat.