Ball Stretcher in Stainless Steel, Two-Part No. 4 3.5 cm

Ball Stretcher in Stainless Steel, Two-Part No. 4 3.5 cm ⚪

This ball stretcher by Metal Hard consists of two half shells in stainless steel that you place around the scrotum above the testicles and join with Allen screws. Because it opens, there is no need to pull it over. The hex key for the screws comes with it. No. 4 is built tall: the ring is almost as high as it is wide and looks more like a short tube than a band. Accordingly there is a lot of steel in it, and you notice that in its weight. It stands with cock rings, under sex toys for men and with fetish sex toys; what else comes from this brand is shown by the brand world of Metal Hard.

✨ At a glance

• 🧵 Material: stainless steel, polished
• 🎨 Colour: Silver
• ⭕ Inner diameter: 3.5 cm
• 📐 Height: tall, almost as high as wide
• 🛠️ Design: two-part, screwed together
• 🔩 Fastening: Allen screws
• 🔧 Tool: hex key included
• ⚠️ Caution: no more than 20 to 30 minutes at first

❓ FAQ

How do you fit it properly?

Put it on when soft. One half goes behind, the other in front; then you turn the screws in alternately until both halves sit cleanly on each other. Move any hair aside first so that nothing gets trapped in the joint.

What does such a tall ring do?

It stretches. Its height pushes the testicles a good way down, and its weight adds extra pull. Unlike a ring in a soft material, it does not give anywhere.

How long can you wear it?

No more than 20 to 30 minutes at first. If you take blood thinners or have circulation problems, talk to a doctor first. Only put it on if it comes off effortlessly again when soft, and take it off at once as soon as numbness, coldness, discolouration, swelling or pain appear. Falling asleep with the ring on is off limits. Keep the hex key within reach at all times, because steel cannot be cut open in an emergency.

How do you care for it?

Unscrew it before and after every use and wash all parts with warm water and mild soap or a product from sex toy cleaner. The threaded bores are where things collect most, so take a second look there. Then dry everything thoroughly.

Do you need lubricant?

It is not necessary, but a little on the inside lets the half shells slide into position more easily. As stainless steel is non-porous, you can use any lubricant, water-based as well as silicone-based.

How do you store it?

Screwed together and dry, ideally in a fabric pouch so that the polish does not get scratched. Put the key right next to it.