Ball Stretcher Master Series Ball Trap Aluminium Silver 11.1 x Ø 6 cm

Ball Stretcher Master Series Ball Trap Aluminium Silver 11.1 x Ø 6 cm 🪤

The Master Series Ball Trap is a ball stretcher of polished aluminium made of two halves. The halves are laid around the scrotum and joined with two screws that are tightened with an Allen key. On each side there is an eyelet from which weights can be hung. The eyelets are teardrop-shaped wire loops, and the screws go in from the side. The ball weights in the illustration are not included. From the Master Series range by XR Brands. It stands under cock rings, with sex toys for men and under fetish sex toys; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: aluminium
• 📏 Dimensions: 11.1 x Ø 6 cm
• 🎨 Colour: silver
• 🛠️ Design: two halves, screwed together
• 🔧 Closure: two screws, Allen key
• ⭕ Eyelets: two, for weights
• ⚠️ Caution: aluminium cannot be cut open
• 🪜 Range: Master Series

❓ FAQ

How do you put it on?

When flaccid and without hurry. Lay both halves around the scrotum above the testicles, insert the screws and tighten them evenly without letting skin get into the gap. Only put it on if it also comes off easily again without an erection.

Where does the Allen key stay?

Always within reach. In an emergency the stretcher cannot be cut open; it only comes off again via the screws. So put the key where you can find it at once, even in the dark.

How long may it stay on?

At first no longer than about 20 to 30 minutes. If you take blood thinners or have circulation problems, talk to a doctor first. At numbness, coldness, discolouration, swelling or pain open it at once, and never fall asleep wearing the stretcher.

What applies when weights hang from the eyelets?

Increase slowly and move calmly. Start light, never let the weights swing or jerk, and keep the wearing time shorter than without. Weights are something for the experienced.

How do you clean it?

With warm water and mild soap. Rinse out the screws and threaded holes thoroughly and dry everything before storing the halves together. You can choose any lubricant, because metal is non-porous.