Masturbator LoveBotz Thunder Stroker Hammer Shape Sucking and Vibrating Silver and Black 23.2 cm

Masturbator LoveBotz Thunder Stroker Hammer Shape Sucking and Vibrating Silver and Black 23.2 cm 🔨

The Thunder Stroker from the LoveBotz range by XR Brands is a suction masturbator shaped like a hammer. The angular head with a round emblem on the side holds the sleeve, whose inside is covered in nubs. The black shaft serves as the grip: four buttons sit on it one below the other, a cap closes it off at the bottom, and a wrist loop hangs from that cap. The stroker combines suction and vibration. The vibration runs in three speeds and seven patterns, the suction has five modes, and the drive turns at up to 7,000 revolutions per minute. It is powered by its built-in rechargeable battery, so no cable gets in the way while you play. It stands under masturbators, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: TPE with a plastic housing
• 📏 Length: 23.2 cm
• 🎨 Colour: Silver
• 🔨 Shape: hammer with a grip and a wrist loop
• 💨 Suction: five modes
• 📳 Vibration: three speeds and seven patterns
• 🔋 Power: rechargeable battery
• 🪜 Range: LoveBotz
• ⚠️ Caution: never hold the device under water

❓ FAQ

Why the hammer shape?

The shaft is a long grip. You hold the device by it and guide the head without having to touch the sleeve itself. You slip the loop at the end over your wrist so that nothing slips away when lubricant gets on your fingers.

How do you start?

With plenty of lubricant and the lowest settings. Put water-based lubricant into the sleeve, start suction and vibration at the lowest level and increase slowly. If you feel pain, numbness, discolouration or blisters, stop at once and switch off.

Which lubricant suits it?

A water-based one. The TPE sleeve is soft and porous; water-based lubricant is gentle on it and washes out easily. You will find suitable ones under water-based lubricant.

How do you clean it?

Only the sleeve is washed. Pull it out of the head, rinse it with warm water and mild soap and let it dry completely in the air before it goes back in. The hammer with the motor and battery is only wiped with a damp cloth.