Nipple Clamps Flower Shape in Metal Silver

Nipple Clamps Flower Shape in Metal Silver 🌼

The Nipple Clamps in Flower Shape from Kink have no jaws. The frame is a silver metal ring whose outline curves like a wreath of petals. Four screws with domed heads sit crosswise in the ring and are turned from the outside towards the centre until they hold the nipple from four sides. A small eyelet sits on the edge of the ring. Two rings are supplied, without a chain. They stand under nipple clamps, with BDSM sex toys and under fetish sex toys; what else comes from this brand is shown by the brand world of Kink.

✨ At a glance

• 🧵 Material: metal
• 🛠️ Design: flower ring with four screws
• ✅ Adjustment: each screw separately
• ⭐ Feature: pressure from four directions
• ✅ Contents: two rings, no chain
• 🎨 Colour: silver

❓ FAQ

How is the ring put on?

First turn all screws well out. Then place the ring so the nipple sits centred in the wreath, and tighten the screws crosswise bit by bit, as when changing a wheel. That way it stays in the middle and is not pushed to one side.

How finely can the pressure be set?

Very finely, because each screw controls its own side. Even a quarter turn changes the feeling. If one side becomes too much, it is enough to turn back just that screw a little.

How long may the flower ring stay on?

Around ten minutes, and never longer than 15 to 20. The pressure comes from all sides here, so circulation runs short sooner than with a jaw clamp. At first, set the screws only firmly enough for the ring to hold. If the nipples turn numb, cold, white or bluish, it comes off at once. When it comes off, the blood flows back and that hurts more for a moment than putting it on: loosen the screws slowly and never pull on the ring while they still grip.

What helps after taking it off?

Hold the nipple in the hollow of your hand until the throbbing eases; rubbing makes it worse. Leave enough of a break between two rounds for colour and feeling to return completely.

How is the ring cleaned?

With warm water and mild soap, the threads with a soft brush. Then dry it thoroughly and leave the screws turned out while it dries, so no water stays in the threads and the metal does not tarnish.