Nipple Clamps Pipedream Super Sucker Trio with Three Suckers

Nipple Clamps Pipedream Super Sucker Trio with Three Suckers ⭕

The Super Sucker Trio from the Fetish Fantasy Series by Pipedream consists of three clear suction cylinders with black twist knobs of different shapes. Two are meant for the nipples, the third for the clitoris. Inside each cylinder a plunger runs on a threaded rod and creates the suction without a pump. It stands under nipple clamps, with BDSM sex toys and under sex toys for couples; what else comes from this brand is shown by the brand world of Pipedream.

✨ At a glance

• ✅ Contents: three suction cylinders
• ✅ Use: two for the nipples, one for the clitoris
• 🔩 Adjustment: twist knob with thread and plunger
• 🧵 Material: plastic
• 🎨 Colour: transparent, knobs black
• 🪜 Range: Fetish Fantasy Series
• ⚠️ Caution: about 10 to 15 minutes, not on broken skin

❓ FAQ

How is the suction created?

Place the cylinder and turn the knob downwards until the plunger touches the skin. Then press the cylinder on firmly and turn the knob back: the plunger moves up, and nipple or clitoris are gently drawn into the cylinder.

How long may the suckers stay on?

Around 10 to 15 minutes. Build the suction up turn by turn and let air in at once if it goes numb, hurts badly or the skin turns dark. When you release them the blood flows back; that moment is often the most sensitive.

How do I take them off?

Do not just pull them off. Lower the plunger again or lift the rim slightly with a fingernail so that air gets in; then the cylinder comes away by itself.

Do they hold by themselves?

As long as the suction holds, yes. A thin film of water-based lubricant on the rim seals it further. With a lot of movement the suction eases, and then you give it another turn.

When do I do without them?

Do not put a sucker on broken, sore or freshly pierced skin. Nothing gets permanently bigger from the suction; the swelling goes down again after removal.

How do I clean the cylinders?

Rinse them with warm water and mild soap, the thread too, and let them dry open. Above all the rim that sits on the skin must be clean. If you share the set, clean each cylinder thoroughly before swapping.