Cock Ring Leather with D-Ring Black 2 cm Wide

Cock Ring Leather with D-Ring Black 2 cm Wide ⭕

This cock ring from KINK is a plain black leather strap that goes around the shaft and scrotum together at the base. It closes with a metal press stud. Right next to it, a small leather loop holds a metal D-ring that sticks out to the side of the strap. This gives the otherwise understated ring an eyelet that a snap hook can clip into. It stands under cock rings, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Kink.

✨ At a glance

• 🧵 Material: leather, metal D-ring and press stud
• 📏 Strap width: 2 cm
• 🛠️ Design: simple strap around shaft and scrotum
• ✅ Attachment: one D-ring in a leather loop
• 🔒 Fastening: press stud
• 🎨 Colour: Black
• 📦 Included: the ring; the dildo in the pictures is not included

❓ FAQ

What is the D-ring for?

It is a fixed eyelet for a snap hook, for example from a lead or a chain. Any pull on it acts directly on the sensitive skin at the base, which is why you never pull or yank on it. With nothing attached, it simply stays a metal detail.

How do you put it on?

While soft, lay the open strap around the scrotum and shaft from below so that the D-ring sits at the side, and press the stud shut. The strap should lie smoothly and not be twisted anywhere.

How tight should it sit?

Noticeable, but not constricting. If a finger no longer fits between leather and skin, it is too tight. A narrow strap presses harder along one line than a wide cuff, so pay particular attention to the edges.

How long may you wear it?

20 to 30 minutes in one go is the limit. If you take blood thinners or have circulation problems, talk to a doctor first. At coldness, numbness, pain or a change in skin colour, take it off immediately; the press stud opens with a firm pull. Never fall asleep with the ring on, and take a break after wearing it.

How do you clean leather and metal?

Wipe the leather with a damp cloth and let it air-dry. It does not tolerate soaking, which makes it hard. Rub the D-ring with a damp cloth and a little soap and then polish it dry so that no water marks remain.