Pump Cylinder Rosebud with Beaded Silicone Insert Black 8.9 x 2.5 cm

Pump Cylinder Rosebud with Beaded Silicone Insert Black 8.9 x 2.5 cm 🔮

The Rosebud cylinder from the Tom of Finland range by XR Brands is a clear acrylic pump cylinder with a black beaded silicone insert, intended for anal play with suction. The cylinder is open at one end, where it has a wide, smooth rim that rests on the skin outside. At the closed end there is a connector for a pump. From the middle of the base the insert reaches out through the opening: three round beads one behind the other, tapering into a slim tip. Because the cylinder is clear, you can see at any time how the skin reacts to the suction. A collector card and a dog tag from Tom of Finland are included; a pump is not. It stands under anal plugs, with anal sex toys and under sex toys for beginners; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: acrylic and silicone
• 📏 Measurements: insert 8.9 cm long, Ø 2.5 cm
• 🎨 Colour: black with a clear cylinder
• 🛠️ Design: pump cylinder with a beaded insert
• 🔌 Connector: for a pump, pump not included
• 📦 Included: cylinder with insert, collector card, dog tag
• 🪜 Range: Tom of Finland
• ⚠️ Caution: for experienced users only, suction slowly and briefly

❓ FAQ

Who is the cylinder intended for?

For experienced users. Anal play with suction requires that you know your body well and are used to stretching without pain. It is not suitable for getting started with anal play.

How do you proceed safely?

Slowly and only briefly. First insert the beaded insert gently with plenty of water-based lubricant until the rim lies flat; the rim stays outside and serves as a stop. Then build up the suction with the pump in small steps and hold it for only a few minutes. At pain, numbness, discolouration or blisters you release the air at once. It is not used on irritated or injured skin.

How do you take it off again?

Never under suction. Let the air escape completely through the pump and only then pull the cylinder and insert out slowly and straight.

How is it cleaned?

With warm, not hot, water and mild soap. Rinse the cylinder and insert thoroughly before and after every use, including around the base of the insert, and let both air-dry. Harsh or alcohol-based cleaners can damage the acrylic.