Anal Spreader Master Series Oculus Stainless Steel Silver 7.4 x 9.4 cm

Anal Spreader Master Series Oculus Stainless Steel Silver 7.4 x 9.4 cm 🔩

The Oculus from the Master Series by XR Brands is an anal spreader in stainless steel, not a plug. It consists of a wide ring and six rods with ball ends that point upwards and are inserted close together; the ring stays outside and serves as a stop. Each rod sits on a threaded bar with a wing nut that runs through the ring; with it you move the rods outwards individually and back again. It stands under anal plugs, with anal sex toys and under sex toys for beginners; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: stainless steel
• 🎨 Colour: silver
• 📏 Measurements: 7.4 cm long, ring Ø 9.4 cm
• 🛠️ Design: ring with six rods with ball ends
• 🔧 Adjustment: individually via wing nuts
• 🪜 Range: Master Series
• ⚠️ Caution: for experienced users only, never open with force

❓ FAQ

Who is the Oculus meant for?

Experienced users only. A spreader works differently from a plug and assumes that you know your body well in anal play and can judge stretching reliably. It is not suitable for beginners.

How is it inserted?

Closed and with plenty of lubricant. Turn all rods fully inwards first, so that they stand close together, and put lubricant on the ball ends and the bottom. Then you insert them slowly until the ring rests outside.

How far may it be opened?

Slowly and only a little. Only ever turn a wing nut slightly and wait to see how it feels before you continue. Never open it with force. At pain you stop at once and turn the rods back.

How does it come out again?

Close it first, then pull it out. Turn all rods fully inwards until they stand close together again, and only then pull it out slowly. It must never be pulled out while open.

Which lubricant suits it?

Water-based or silicone-based lubricant. Stainless steel tolerates both. Use plenty of it and add more part-way through, because the rectum does not become moist by itself.

How is it cleaned?

With warm water and mild soap. Clean the threads and wing nuts with a soft brush. Dry everything thoroughly so that no water stays in the threads.