Ball Stretcher in Stainless Steel, Two-Part No. 5 3.5 cm

Ball Stretcher in Stainless Steel, Two-Part No. 5 3.5 cm ⚪

The two-part ball stretcher No. 5 by Metal Hard is made of polished stainless steel. Its two halves enclose the scrotum above the testicles and are held together on both sides with Allen screws; a hex key is included. To put it on you open it instead of pulling it over the testicles. It is a tall ring whose height comes close to its width, and the steel shines mirror-smooth inside and out. It stands with cock rings, under sex toys for men and with fetish sex toys; what else comes from this brand is shown by the brand world of Metal Hard.

✨ At a glance

• 🧵 Material: stainless steel, polished
• 🎨 Colour: Silver
• ⭕ Inner diameter: 3.5 cm
• 📐 Shape: tall, almost as high as wide
• 🛠️ Build: two halves
• 🔩 Connection: Allen screws on both sides
• 🔧 Accessory: hex key
• ⚠️ Caution: no more than 20 to 30 minutes at first

❓ FAQ

How do you get it into position?

When soft, you place the first half behind the scrotum and the second in front. Then you tighten both sides alternately until there is no gap left, and check that no skin or hair is caught in the joint.

What is the height good for?

For pull. Such a tall ring keeps the testicles at a distance from the body, and its weight adds to that. This pulling is exactly the appeal of a ball stretcher.

What applies to wearing time?

Start with no more than 20 to 30 minutes. Only put it on if the ring comes off easily again when soft. Numbness, coldness, discolouration, swelling or pain are the signal to remove it at once. Do not fall asleep with it and always keep the key within reach: a steel ring cannot be cut open in an emergency.

How do you clean the individual parts?

Take out the screws and rinse halves, screws and bores before and after every use with warm soapy water or a product from sex toy cleaner. The non-porous steel absorbs nothing. Let everything dry completely before you screw it back together.

Can you use any lubricant?

Yes. Stainless steel reacts neither with water-based nor with silicone-based lubricant, and a thin film on the inside makes fitting the second half easier.

How do you store it?

Dry and screwed together so that no screw gets lost. Keep it apart from other metal items so the polish stays free of scratches, and keep the key right beside it.