Ball Vice Ball Buster in Wood Black 10.4 cm

Ball Vice Ball Buster in Wood Black 10.4 cm 🗜️

The Ball Buster by Steel is a ball vice made of black lacquered wood. At the top sits a two-piece block with an oval opening, which is placed around the scrotum and closed at the sides with two wing nuts; below it lies a flat plate. Two long threaded rods connect both parts. With the two upper wing nuts you draw the plate towards the block and so decide how strongly the testicles between them are pressed together. The threaded rods and nuts are metal, and the wooden parts have rounded corners. It stands under cock rings, with sex toys for men, under sex toys and with the sex toys. More for this kind of play can be found under BDSM sex toys.

✨ At a glance

• 🧵 Material: wood, black lacquered; threaded rods and nuts in metal
• 🎨 Colour: black
• 📏 Dimensions: 10.4 cm long, 13.8 cm wide, 8 cm high
• ⚖️ Weight: 320 g
• 🔩 Build: block with opening, base plate, two threaded rods, four wing nuts
• ⚠️ Caution: finger-tight only, 20 to 30 minutes at most

❓ FAQ

How is it put on?

First the block, then the plate. Undo the side wing nuts, place the two halves of the block around the scrotum above the testicles and close them again. The opening must not constrict, and no skin may get caught in the joint. Then bring the base plate up from below along the threaded rods until it just touches the testicles.

How tight may it be done up?

Slowly, lightly and with the fingers only. Turn the upper nuts just a quarter turn at a time and wait in between to see how it feels; never tighten further with a tool. Even a few turns create a lot of pressure.

How long may it be worn?

Briefly, 20 to 30 minutes at most in total. If you take blood thinners or have circulation problems, talk to a doctor first. At any pain, numbness, coldness or discolouration, turn back at once and take it off. Never tug at it. It cannot be cut open; it only opens via the wing nuts, which therefore always stay within easy reach. Whoever wears it is never left alone, and you agree on a stop signal beforehand.

How is it cleaned?

Wipe it damp, do not soak it. Clean the wooden parts before and after use with a damp cloth and a little mild soap and dry them straight away. The threaded rods and nuts can be unscrewed and cleaned separately. Store everything dry so the wood does not warp.