Cock Ring Ohmama with Vibration and Bunny Ears Black

Cock Ring Ohmama with Vibration and Bunny Ears Black 🐰

The cock ring by Ohmama in black silicone carries a small housing above the ring in which a bullet sits crosswise. Above it sits a bunny figure with two long ears curving forwards. The bullet has one vibration mode and runs on three L1154F button cells; its button sticks out of the housing at one end. It stands under cock rings, with sex toys for couples and under sex toys for men; what else comes from this brand is shown by the brand world of Ohmama.

✨ At a glance

• 🧵 Material: silicone and ABS
• 🎨 Colour: black
• 📏 Length: 3 cm
• 🐰 Attachment: bunny with two ears
• 📳 Vibration: one mode, removable bullet
• 🔋 Batteries: 3 x L1154F
• ⚠️ Caution: wear for no more than 20 to 30 minutes

❓ FAQ

How long may it be worn?

For no more than twenty to thirty minutes at a time. If you notice numbness, coldness, discolouration or pain, take it off immediately, and never sleep with it on.

How do I put it on?

Ideally while the penis is not yet fully erect: stretch the ring a little, slide it down the shaft to the base and turn it so that the bunny points upwards. If it feels too tight, leave it off.

What are the bunny ears for?

They are made of the same soft silicone as the ring and pass the vibration of the bullet to the outside. In positions with close body contact they rest against the partner’s clitoris or mons pubis.

Who is it meant for?

For couples who want to bring vibration into sex without holding a toy in their hand. The wearer feels it directly at the base of the penis. You will find more models under cock rings.

Can the bullet be changed?

Yes, it is removable. That lets you replace the button cells when the vibration weakens.

Which lubricant is suitable?

A water-based one. It is gentle on the silicone and makes it easier to slip the ring on.

How is it cleaned?

Before and after every use: take out the bullet, wash the ring with warm water and mild soap or toy cleaner and just wipe the bullet with a damp cloth. Let everything dry before putting it back together.