Masturbator Creature Cocks Pussidon Sea Monster Silicone Blue 22 x Ø 9 cm

Masturbator Creature Cocks Pussidon Sea Monster Silicone Blue 22 x Ø 9 cm 🌊

Pussidon from the Creature Cocks range by XR Brands is a stroker shaped like the vulva of a sea monster. The light blue silicone insert has soft, raised lips around a small oval opening, with folded flaps standing above it like a crest. The surface is smooth and without scales. The insert sits in a rigid case with a cap to put on. The cap has a ribbed rim all round. Behind the tight opening the canal is textured inside, and the closure at the bottom of the case sets the suction. It stands under masturbators, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: silicone with an ABS case
• 📏 Length: 22 cm
• ⭕ Diameter: 9 cm
• 🎨 Colour: blue
• 🌊 Opening: soft lips, small oval opening, crest above
• 💨 Suction: closure at the bottom of the case
• 🧢 Cap: to put on
• 🪜 Range: Creature Cocks

❓ FAQ

Is the small opening not too tight?

It stretches. The silicone gives way on entry and then fits closely around the shaft. Go in slowly and with enough lubricant, never with force: if something resists, add more and try again.

When is the closed closure worth it?

When it should get tighter. With the bottom closed, the air stays in the case and the insert pulls along with every movement. Leave it open to begin with and close it later.

Which lubricant suits it?

Only water-based. Silicone-based lubricant can roughen the surface of the insert. A dab into the opening, one on the shaft, then add more as needed. Suitable ones stand under water-based lubricant.

How is Pussidon cleaned?

Wash the insert on its own. After every use pull it out of the case and flush it thoroughly with warm water and mild soap. Residue shows on the light blue, so keep rinsing until the canal is clear.

How does it dry properly?

Open and with time. Let insert and case air-dry separately, opening facing down. Only when everything inside is dry, put the insert back and fit the cap.