Masturbator for the Glans in Silicone Adjustable with Vibration Black 6 x 6 cm

Masturbator for the Glans in Silicone Adjustable with Vibration Black 6 x 6 cm ⚫

A masturbator in silicone by Levelz in black: a short, helmet-shaped sleeve with grooves on top and an adjustable strap with a row of holes at the side. Below the domed top a wide slit opens at the side, and the surface is matt. A motor for the vibration sits inside the sleeve. It stands with masturbators, under sex toys and with sex toys for men; what else comes from this brand is shown by the brand world of Levelz.

✨ At a glance

• 📏 Measurements: 6 x 6 cm
• 🧵 Material: Silicone
• 🎨 Colour: Black
• 🔧 Adjustment: strap with a row of holes
• 🔋 Features: vibration, rechargeable battery with USB cable

❓ FAQ

What sets it apart from an ordinary masturbator?

The length. An ordinary masturbator takes the whole shaft, this one sits on the glans only, where most of the nerves are. That is a different stimulus, not a smaller one.

What is the adjustment for?

Because a fixed sleeve either slips or presses. The holes let you choose in steps how firmly the sleeve sits, and with it how strong the stimulus turns out. Only close the strap so far that nothing constricts.

How do you put it on?

Open the strap, place the sleeve on the glans with a little lubricant and then pull the strap through until the sleeve holds without pressing. To take it off, open the strap again rather than pulling on the sleeve.

How is it charged?

Over a USB cable. A full charge before first use never hurts, because batteries run flat by themselves after long storage. Charging runs over contacts on the housing rather than an open socket.

How is it cleaned?

With a damp cloth, lukewarm water and mild soap or a cleaner from sex toy cleaner; do not submerge it, because the electronics sit inside. Then let it dry in the open, as silicone picks up odours if it is put away damp.

Which lubricant goes with it?

Only a water-based one from water-based lubricant. Silicone lubricant attacks silicone surfaces: over time they turn sticky and rough, and that cannot be undone.