Masturbator Jock Auto Spin Rotating and Thrusting Black 13 x Ø 8.1 cm

Masturbator Jock Auto Spin Rotating and Thrusting Black 13 x Ø 8.1 cm 🖤

The Masturbator Jock Auto Spin by Curve Toys takes the movement off your hands: it rotates and thrusts, with the thrusting at three speeds. The black handle with a red control panel holds the motor and battery, and you operate it with four buttons, each with its own symbol, and a red ring runs round the end of the handle. In front of it sits a transparent cylinder with a TPE sleeve inside. At the front the cylinder is closed off by a black ring with a soft, transparent entrance. Charge it before use. TPE is porous: the surface has fine pores that cannot be got completely germ-free, unlike dense silicone. That leads to a simple habit: clean it after every use, and share it only with a condom. It sits under masturbators, under sex toys for men and in our sex toys section.

✨ At a glance

• 🧵 Material: TPE and ABS
• 🎨 Colour: Black
• 📏 Dimensions: 13 x Ø 8.1 cm
• 👉 Use: Charge before use, water-based lubricant
• ✅ Care: Cylinder off, rinse the sleeve, let it dry
• 🔘 Controls: Four buttons on the handle
• ⭐ Special feature: Rotation and thrusting, thrusting at three speeds

❓ FAQ

How loud is a device like this?

Audible. Anything that rotates and thrusts works with mechanics, and mechanics make noise; in a thin-walled house that is the point to think about beforehand.

What does the sleeve look like inside?

It is lined all round with long, cone-shaped nubs pointing inwards. It sits in a holder with side windows, through which you can see the nubs from the outside too.

Which lubricant fits?

A water-based one, and plenty of it. Silicone oil attacks silicone, oil attacks soft plastics. The selection is under water-based lubricant.

How is it cleaned?

Cylinder off, rinse the sleeve with lukewarm water, let it dry completely, and only wipe the handle. Only put the cylinder back on once everything is dry.

How do you start?

Put lubricant into the entrance and on the penis, slide it on and only then switch on rotation and thrusting, with the thrusting at the lowest speed first.