Masturbator LoveBotz Milker Max Thrusting and Vibrating TPE Black 27.4 cm

Masturbator LoveBotz Milker Max Thrusting and Vibrating TPE Black 27.4 cm 🤖

The Milker Max from the LoveBotz range by XR Brands thrusts and vibrates. There are three speeds, plus four thrusting patterns and four vibration patterns. At the front sits a white TPE sleeve, ribbed in a spiral on the outside, with a small opening behind which nubs can be seen. The black housing carries a hexagonal, blue-lit button panel with three buttons, and a black cap covers the opening. It stands under masturbators, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: TPE sleeve, plastic housing
• 📏 Length: 27.4 cm
• 🎨 Colour: black
• 📳 Drive: thrusting and vibration
• ✅ Speeds: three
• ✅ Patterns: four for thrusting, four for vibration
• 🧢 Cap: covers the opening
• 🪜 Range: LoveBotz

❓ FAQ

What does thrusting change compared with vibration?

The movement. When thrusting, the sleeve works back and forth along the shaft, and the vibration adds a fine trembling. With the patterns, rhythm and pauses change.

How is it held while it thrusts?

Steady, with one hand on the housing. Keep the button panel facing up so the buttons stay within reach of your thumb. Because the sleeve moves by itself, the hand only has to hold; a firm grip stops the device wandering with the thrusting movement.

How do you start?

At the lowest speed and with plenty of lubricant. Put lubricant on the shaft and into the opening, then switch on and increase slowly. With pain, numbness or skin irritation switch off at once.

Which lubricant suits TPE?

Only a water-based one. Oil and silicone-based lubricant attack the soft sleeve. Suitable ones stand under water-based lubricant.

How is it cleaned?

Sleeve out, housing only wiped. Flush the sleeve with warm water and mild soap, rinse with clear water and let it dry completely. The device with the motor is only wiped with a damp cloth and never held under water.

How is it stored?

Dry, with the cap on. Only once the sleeve sits completely dry in the housing again does the cap go on. TPE is porous and takes on colour, so the milker is kept apart from other toys.