Masturbator Set Master Series Overload with a Gas Mask and Hose Black and Clear 10.7 cm

Masturbator Set Master Series Overload with a Gas Mask and Hose Black and Clear 10.7 cm 🎭

The Overload by XR Brands from the Master Series range is a four-piece fetish set: a black silicone gas mask with two large lenses and adjustable silicone head straps, a black corrugated hose, a white plastic bottle and a clear masturbator sleeve. The hose screws onto the front of the mask and onto the bottle. The mask is made in one size that fits most; aluminium and polycarbonate are used on it, and the sleeve is made of rubber. It stands under masturbators, with erotic masks and under fetish sex toys; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: mask silicone, aluminium and polycarbonate, sleeve rubber
• 🎨 Colour: black and clear
• 🧩 Contents: mask, hose, bottle, sleeve
• 📏 Sleeve: 10.7 cm deep
• 📏 Hose: 51.3 cm, 40 mm thread
• 🍶 Bottle: up to 1 l
• 🧴 Lubricant: water-based only
• 🪜 Range: Master Series
• ⚠️ Caution: never restrict breathing, never leave alone

❓ FAQ

What applies to breathing?

Mask, hose and sleeve must never restrict breathing: air must be able to flow in and out freely at all times, and the air supply is never deliberately limited. Whoever wears the mask is never left alone for a moment and must be able to take it off themselves at any time, so the hands stay free. In case of shortness of breath, dizziness or panic, take it off immediately.

How does the mask sit?

The head straps adjust at the back of the head until the mask sits snugly but without pressure points. Never tighten it so much that it cannot be taken off again in one movement. Agree on a signal without words beforehand, because speech is hard to understand under the mask.

Which lubricant suits the sleeve?

Water-based lubricant only. Rinse the sleeve with warm water after every use and let it dry completely. If you share it, it does not replace a condom; clean it thoroughly before every change.

How do you clean mask, hose and bottle?

Rinse mask and bottle with warm water and mild soap. Flush the hose through and let it dry hanging so that no moisture stays inside. Everything must be completely dry before you put it away.