Masturbator The Milker with a Ball Strap Dual Texture TPE Clear 19.8 x Ø 7.1 cm

Masturbator The Milker with a Ball Strap Dual Texture TPE Clear 19.8 x Ø 7.1 cm 🪢

This masturbator from The Milker range by XR Brands is a clear, soft and stretchy TPE sleeve that works without a motor. On the outside, bold ribs run round the sleeve; on the inside, a canal with two different textures leads upwards, so the feel changes on the way in. At the bottom end there is a strap that keeps the sleeve in place so that it does not slip off while you play. On the side the sleeve has a pocket that fits a small bullet; a bullet is not included. At the top the sleeve runs into a narrow nozzle. Because the material is clear, you can see what happens inside. It stands under masturbators, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: TPE
• 📏 Length: 19.8 x Ø 7.1 cm
• ⭕ Diameter: 7.1 cm
• 🎨 Colour: clear
• ✅ Canal: two textures, ribbed
• 🪢 Hold: ball strap
• 📳 Drive: none, pocket for a bullet (not included)
• 🪜 Range: The Milker
• ⚠️ Caution: wear the strap for 20 to 30 minutes at most

❓ FAQ

How do you put the strap on properly?

While relaxed and without pulling. First put water-based lubricant into the sleeve and onto the shaft, slide it on and then lead the strap under the testicles. It should sit snugly without cutting in or pinching skin.

How long may the strap stay on?

For 20 to 30 minutes at a time at most. If you take blood thinners or have circulation problems, talk to a doctor first. If you feel numbness, coldness, discolouration or pain, take the sleeve off at once. Never fall asleep with the strap on, and take a longer break between two rounds.

Which lubricant suits TPE?

Only a water-based one, and plenty of it. TPE is porous and tolerates neither oil nor silicone-based lubricant. Top up the lubricant as soon as the sleeve starts to drag. You will find suitable ones under water-based lubricant.

How do you clean and dry the sleeve?

With lukewarm water, then dry it thoroughly. Rinse the canal with mild soap after every use, remove any bullet you put in beforehand and let the sleeve dry openly in the air until no moisture is left inside. A light dusting of cornflour afterwards keeps the TPE silky rather than tacky.