Milking Cylinder LoveBotz with a Textured Sleeve Acrylic and Latex Natural 24.1 cm

Milking Cylinder LoveBotz with a Textured Sleeve Acrylic and Latex Natural 24.1 cm 🥛

This milking cylinder from the LoveBotz range by XR Brands is an accessory for The Milker milking machine. It consists of a clear acrylic tube holding a skin-coloured latex sleeve. The sleeve is covered with rows of small nubs and is held at the top and bottom by black rings that seal the tube. On the side at the lower end there is a connector with a metal thread for the machine's suction hose. When the machine runs, it draws the sleeve round the shaft in rhythm and releases it again. That way you add another long textured cylinder to your machine. It stands under masturbators, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: acrylic and latex
• 📏 Length: 24.1 cm
• 🎨 Colour: natural
• ✅ Sleeve: with nubs
• 🔩 Connector: thread for the suction hose
• 🛠️ Fits: The Milker milking machine
• 🪜 Range: LoveBotz
• ⚠️ Caution: contains latex, water-based lubricant only

❓ FAQ

What do you need to know about latex?

Allergy, lubricant and storage. If you have a latex allergy, do not use the cylinder. Oil, greasy creams and oil-based lubricants destroy latex, so only water-based lubricant will do. Keep it dark and cool so that the sleeve does not become brittle. You will find suitable lubricant under water-based lubricant.

How do you start?

With plenty of lubricant and the machine at its lowest level. Put the lubricant into the sleeve and onto the shaft, place the cylinder and only turn the pace up once it feels good. Make sure the testicles are not drawn into the cylinder.

How long may the suction run?

Only a few minutes at a time, then a break. If you feel pain, numbness, discolouration or blisters, switch the machine off at once and take the cylinder off. It is not used on broken skin.

How do you clean it?

With warm water and mild soap. Pull off the hose, rinse the tube and sleeve thoroughly and let both dry openly in the air. Leave out harsh cleaners and hot water, because they attack the latex.