Nipple Suckers Size Matters MAXtwist 2 Pieces White 10.3 cm

Nipple Suckers Size Matters MAXtwist 2 Pieces White 10.3 cm 🌀

The MAXtwist from the Size Matters range by XR Brands are two nipple suckers with a twist mechanism. Each consists of a clear cylinder with a wide rim, a white twist cap with a wavy grip edge and a blue inner part through which a white threaded rod runs downwards. At the lower end sits a piston with a black seal. If you turn the cap, the threaded rod draws the piston up, and a vacuum builds in the cylinder. The opening is wide enough to take the nipple together with part of the areola. They stand under nipple clamps, with sextoys for women and under fetish sex toys; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: plastic
• 📏 Length: 10.3 cm
• ⭕ Inner diameter: 3 cm
• 🎨 Colour: white
• 🔢 Contents: two suckers
• 🎛️ Operation: twist cap with threaded rod and piston
• 🪜 Range: Size Matters
• ⚠️ Caution: only briefly, release at once if it hurts

❓ FAQ

How do you put them on?

With the cap turned back. Place the rim flat and centred around the nipple, press it on lightly until it seals all round, and hold the cylinder steady while you turn.

What does the clear cylinder offer?

A view of what happens inside. How far the nipple is drawn in and how the skin looks stays in view the whole time, instead of you relying on feel alone.

How do you take them off again?

By turning back. Turn the cap back until the piston sits in its starting position again and no suction can be felt. Then the cylinder comes away by itself; never pull it off while it is still sucking.

How long may the suckers stay on?

Only briefly, a few minutes at a time. Build up the vacuum slowly, with small turns and pauses, and do not put the suckers on injured or irritated skin. In case of pain, numbness, discolouration or blisters, turn back at once and take them off.

How do you clean them?

With warm water and mild soap. Rinse the cylinders out from below, wipe piston and rim and let everything air dry before you put the suckers away.