Nipple Clamps Vice Style Silver

Nipple Clamps Vice Style Silver 🔩

The Nipple Clamps Vice Style Silver by Kink are two small screw clamps of bare metal. A bent frame holds a movable pressure bar that is adjusted by a threaded spindle with a knurled knob. The two clamps are separate and not joined by a chain. They stand under nipple clamps, with BDSM sex toys and under fetish sex toys; what else comes from this brand is shown by the brand world of Kink.

✨ At a glance

• 🧵 Material: metal
• 🛠️ Design: screw clamp with spindle
• ✅ Adjustment: stepless via the spindle
• ⭐ Feature: no spring travel, no give
• ✅ Contents: two separate clamps, no chain
• ⚠️ Caution: wear for 15 to 20 minutes at a time at most
• 🎨 Colour: silver

❓ FAQ

What sets the spindle apart from a spring clamp?

It does not give way. A spring flexes and limits itself; the spindle turns as far as you turn it and then holds the pressure exactly there. That allows a very precise setting and demands attention when tightening.

How do you put them on properly?

Place them fully open, then tighten. Lay the nipple between frame and pressure bar and turn the knob slowly. Never push the clamp on pre-tightened, or the edge pinches before the bar is in contact.

Why no chain?

So that both sides stay independent. Each clamp can be placed, readjusted and released on its own.

What does the bare metal mean?

There is no padding. Frame and pressure bar rest directly on the skin, so every turn takes effect immediately. If the metal feels cold, warm the clamps briefly in your hand first.

How long may the clamps stay on?

15 to 20 minutes at a time at most. Start with just enough pressure for the clamp to hold, and tighten only in small steps. Numbness, cold or a white to bluish colour mean: release at once. On removal the blood flows back, and that is the strongest moment: turn the spindle open slowly, take off one clamp after the other and never pull them off while closed.

How do you clean the clamps?

With warm water and mild soap. Rinse frame, bar and thread, dry thoroughly and then turn the spindle all the way through once so that no water stays in the thread.