Nipple Clamps with Jingle Bell on a Chain Silver 6 cm

Nipple Clamps with Jingle Bell on a Chain Silver 6 cm 🎐

Here a short chain of a few links sits between the clamp and the gold jingle bell, attached with a ring at the top and bottom. The clamps themselves have black-covered jaws and a knurled screw on the side. They stand under nipple clamps, with BDSM sex toys and under fetish sex toys; what else comes from this brand is shown by the brand world of Kink.

✨ At a glance

• 🧵 Material: metal with silicone tips
• 📏 Measurements: 6 cm per clamp
• ✅ Pendant: one gold jingle bell per clamp
• 🛠️ Design: bell on a short chain
• ✅ Adjustment: knurled screw
• ✅ Contents: two separate clamps
• 🎨 Colour: black with a gold bell

❓ FAQ

When does the bell ring?

Even with small movements. A shrug or a deep breath is enough to make it rattle. Anyone told to keep still is reliably given away by it.

What does the short chain do?

More swing and a noticeable pull. The bell hangs lower than with a direct suspension and keeps swinging after every movement. In doing so it briefly pulls harder on the clamp before hanging still again.

Can I wear the clamps singly?

Yes. The two clamps are not connected; each carries its own bell. Starting with one side is a good way to get to know the feeling.

What do I need to watch out for?

Pressure, time and removal. Start with the knurled screw loose and tighten it only until the clamp holds; white skin means it is too tight. Wear the clamps for a few minutes at first and never more than 15 to 20 minutes at a stretch. If the nipple becomes numb, cold or bluish, take the clamp off at once. When removing them the blood flows back, so it pulls more than putting them on: open one clamp after the other and never pull on the chain or bell.

How do I clean the chain and bell?

Rinse with warm water and mild soap, shake the bell out with the slot facing down and dry everything with a cloth. Lay the chain out straight to finish drying so no moisture remains in the links.

What do the black covers do?

They spread the pressure over more surface. Without a cover two narrow metal edges would grip; this way the clamp rests more broadly.