Nipple Clamps with Three O-Rings Silver 6 cm

Nipple Clamps with Three O-Rings Silver 6 cm ⭕

Three metal rings hang beneath each of these nipple clamps, interlocking like chain links; the lowest is the largest. A small ring connects them to the base of the clamp. The clamps hold with black-covered jaws and can be adjusted with a knurled screw on the side. They stand under nipple clamps, with BDSM sex toys and under fetish sex toys; what else comes from this brand is shown by the brand world of Kink.

✨ At a glance

• 🧵 Material: metal with silicone tips
• 📏 Measurements: 6 cm per clamp
• 🛠️ Design: three interlocking rings per clamp
• ✅ Adjustment: knurled screw
• ✅ Contents: two separate clamps, no chain
• 🎨 Colour: black with silver rings

❓ FAQ

What do the three rings do?

They work through their weight. The rings pull the clamp downwards constantly, and because they hang loosely inside one another, every movement sets them swinging again. As they do, they clink softly against each other.

Can I attach something to the rings?

Yes, the lowest ring has room for it. A chain with a snap hook, a light weight or a small bell can be hooked on there; none of these are included. More weight means more pull, so increase it carefully.

Why are the jaws covered in black?

The cover cushions. It rests more broadly than the bare metal edge and so spreads the pressure the screw creates.

How do I wear the clamps responsibly?

With little pressure, little time and calm when taking them off. Turn the knurled screw loose before putting them on and tighten it only until the clamp holds; if the skin turns white, it is too much. Start with a few minutes and never wear them longer than 15 to 20 minutes at a stretch. If the nipples become numb, cold or bluish, take the clamps off at once. Taking them off pulls harder than putting them on, because the blood flows back; so open the clamps one at a time and never pull on the rings.

How do I clean the rings?

Wash rings and clamps with warm water and mild soap, paying attention to the places where the rings interlock. Then dry them with a cloth and leave them out until the joint of the clamp is dry too.