Accessories Vibration Band with a Bullet for Penis Pumps Black

Accessories Vibration Band with a Bullet for Penis Pumps Black ⚫

The Vibration Band for Penis Pumps by Pump Addicted is called “Universal Sleeve & Vibrating Bullet” in the original and adds vibration to a pump. It consists of a flexible black ABS band. On one side it holds a bullet with a silver tip in a hollow, on the other an elongated control unit with a small wheel on top. The set runs on two AA batteries. Because everything sits on the outside, the inside of the cylinder stays free. The material is free of phthalates. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pump Addicted.

✨ At a glance

• ✅ Type: accessory for penis pumps
• 🧵 Material: ABS
• 🎨 Colour: black
• ✅ Build: flexible band, bullet, control unit
• 🔋 Batteries: 2 x AA
• 🔗 Use: on the outside of the pump cylinder
• ⚠️ Caution: the pump rules still apply

❓ FAQ

How is the band attached?

It is wrapped around the cylinder. The band is flexible and meant as a universal accessory; it hugs the curve of the wall. Whether it sits tightly enough on your pump depends on the diameter of the cylinder.

What is in the set?

Only the vibration accessory. The pump cylinder in the pictures is not included; the band goes on your own pump.

What applies when pumping with vibration?

The same rules as without. Build up the vacuum slowly and hold it for only a few minutes at a time. If you feel pain or numbness, or notice discolouration or blisters, let the air out at once. The testicles stay outside the cylinder, you do not pump on injured skin, and any scale or gauge on the pump is only a guide.

How does the pump stay sealed?

Through a rim that lies flat. Place the cylinder on straight before you switch on the vibration. A drop of lubricant on the rim of the pump helps it seal; suitable ones are under water-based lubricant.

How do you clean the band?

Only with a damp cloth. Take the batteries out first. The band, bullet and control unit do not go under running water; afterwards everything dries in the air.