Penis Ring Power Ring with Vibration Black

Penis Ring Power Ring with Vibration Black ⭕

The Penis Ring Power Ring with Vibration by Baile consists of a black ring with a nubbed holder carrying a silver vibrating bullet. You switch through the ten programmes with the button on the bullet; three LR44 button cells power it. The ring has several small cut-outs, the holder is densely nubbed all round and open at one side. The button sits at the end of the bullet and sticks out of the holder. Put it on while soft. It sits under cock rings, under sex toys for men and in our sex toys for couples section.

✨ At a glance

• 🧵 Material: TPR, ABS
• 🎨 Colour: Black
• ✅ Water protection: splash proof, not submersible
• 🔋 Vibration: 10 programmes, 3 x LR44
• ✅ Bullet: silver, removable, button at the end
• 📏 Inner diameter: 2.8 cm

❓ FAQ

How long may it be worn?

20 to 30 minutes at a stretch at most. If anything goes cold or numb, the skin changes colour or it hurts, take it off at once, and sooner rather than later if in doubt. Never fall asleep wearing the ring. Then take a break before putting it on again.

Which size fits?

The one that holds without hurting. A ring that hurts is too small; one that slips is too large. If unsure, start with a wider one; sets with several widths take that decision off your hands.

How does it come off again?

With cold water and patience, not with force. The congestion eases as soon as things cool, and then it comes off by itself. A stretchy ring can also be widened carefully.

Which lubricant fits?

A water-based one; a drop when putting it on is all it takes. The selection is under water-based lubricant, further rings under cock rings.

How do you change the button cells?

Pull the bullet out of the holder and unscrew the end cap. The three button cells lie stacked inside; mind the direction of plus and minus when inserting them and screw the cap firmly back on afterwards.

How do you clean it?

Take the bullet out and wipe the ring and holder with warm water and a sex toy cleaner. Only wipe the bullet with a damp cloth, as it is not submersible. Let everything dry before you put it back together.