Penis Pump Basic 1 Water-Resistant Orange 20 x 6.5 cm

Penis Pump Basic 1 Water-Resistant Orange 20 x 6.5 cm 🧡

Two grip strips made of small ribs run along the sides of the cylinder of the Basic 1 penis pump from Pumped. The cylinder itself is translucent orange, with three arches in a darker shade printed on it. Its closed tip carries a black connector for the coiled tube, and at the bottom a soft black sleeve finishes the rim. Pumping is done with a black hand bulb with a grid texture, with a valve sitting above it. The pump is water-resistant and works without any electrics. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pumped.

✨ At a glance

• 🧵 Material: silicone and ABS
• 🎨 Colour: orange, translucent
• 📏 Cylinder: 20 x 6.5 cm
• ✋ Grip: ribbed strips on both sides
• 🖐️ Pump: hand bulb with a valve
• 💧 Water protection: water-resistant, no electrics
• ⚠️ Caution: increase the suction gently, hold it only briefly

❓ FAQ

How do you use it?

A little water-based lubricant on the rim of the sleeve, put the cylinder on, hold it by the ribs with one hand and squeeze the bulb with the other. At the end you open the valve, wait until the cylinder sits loosely, and take it off.

What matters for safety?

Start slowly and hold the vacuum for only a few minutes, then let the air out and pause. Pain, numbness, a discoloured patch or blisters end the session at once: open the valve, take the cylinder off. Only the penis goes into the cylinder, never the testicles, and with injured or irritated skin you leave the pump alone.

What if you wear a cock ring afterwards?

Then an upper limit of 20 to 30 minutes applies. If you take blood thinners or have circulation problems, talk to a doctor first. Numbness, coldness, discolouration or pain means: take it off at once. You never fall asleep with a ring on.

How do you tell that the cylinder needs replacing?

By cracks or chipped spots. A damaged cylinder no longer holds a vacuum and can injure the skin with sharp edges, so take a quick look at it before every use.

What does it need after use?

Sleeve off, then wash out both parts, it and the cylinder, in warm water with a little mild soap. Wipe the bulb and tube with a damp cloth. Let everything dry thoroughly and store it free of dust.