Penis Pump RX3 with Sleeve Black 23 x 5.5 cm

Penis Pump RX3 with Sleeve Black 23 x 5.5 cm ⚫

The tinted RX3 from Pump Addicted comes here together with a Pleasure Sleeve in size M. The sleeve is soft, clear TPE, its opening is shaped like a vulva, and nubs and ribs run inside. It goes into the cylinder; when you then pump air out with the bulb, the material is drawn onto the penis. Without the sleeve, the RX3 remains a hand pump with a smoky black cylinder, hose and release valve on the bulb. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pump Addicted.

✨ At a glance

• ✅ Type: penis pump with sleeve
• 🧵 Material: ABS and TPE
• 🎨 Colour: black
• 📏 Dimensions: 23 x Ø 5.5 cm
• 📳 Drive: hand bulb
• ✅ Accessory: Pleasure Sleeve size M
• ✅ Release valve: on the bulb

❓ FAQ

How do you fit the sleeve?

Push it into the cylinder narrow end first. The wide collar settles over the rim on the outside and seals there. If it sits crooked, the pump draws in stray air; then simply fit it again.

Which lubricant suits the sleeve?

Only a water-based one. Oil and silicone lubricant make TPE permanently dull and sticky. You will find a selection under water-based lubricant.

How do you use the bulb?

With short, calm squeezes. Each one takes only a little air out of the cylinder, and the grid relief on the bulb gives grip. To release, open the small valve between hose and bulb, and the air flows back.

What limits apply when pumping?

Build the vacuum slowly and hold it for only a few minutes, then take a break. With pain, numbness, discolouration or blisters, release the air at once. The testicles stay outside the cylinder, and injured or irritated skin is off limits.

How are pump and sleeve cleaned?

Each part on its own. Rinse the inside of the sleeve with warm water, wash the outside with soap and let it dry upside down; a touch of powder keeps it from going tacky. Wash out the cylinder with soapy water, and only wipe the bulb and hose so that no water runs into the valve.