Strap-on Harness with Three Rings Black

Strap-on Harness with Three Rings Black 🖤

The Strap-on Harness by Rock Army is the harness on its own, without a dildo: four straps, a padded plate at the front and three flexible retaining rings in sizes S, M and L. The plate is triangular and covered in black PU leather. The ring sits in its centre and is held by two tabs with press studs, so it can be swapped without tools. Two nylon straps run around the hips, two more lead from the back panel under the bottom to the front. The back panel is padded and laced up like a corset, and a buckle at the side sets the width. Thanks to the rings the harness fits dildos of different thicknesses; anyone who already owns one does not need a complete set. It stands under strap-ons, with dildos and under sex toys; what else comes from this brand is shown by the brand world of Rock Army. Lubricant for the dildo stands under water-based lubricant.

✨ At a glance

• ✅ Type: strap-on harness, without a dildo
• 🧵 Material: PU leather, nylon straps, rubber rings
• 🎨 Colour: Black
• ✅ Straps: four, adjustable
• ✅ Rings: three, S, M and L, flexible
• ✅ Holder: two tabs with press studs
• ✅ Back panel: padded, lace-up
• ✅ Care: wipe clean, store dry

❓ FAQ

Which ring fits my dildo?

The one that closes snugly around the shaft. Work up from the smallest ring: the shaft should sit tight without wobbling, and the base of the dildo must be wider than the ring, otherwise it slips through. All Rock Army dildos fit, whereas a dildo without a pronounced base will not hold in any ring.

How do you put the harness on?

Hips first, then the legs. Put the hip straps around your waist and then lead the two leg straps under your bottom to the front. Pull every strap smooth before closing it, because twisted bands are the most common cause of pressure marks. Finally tighten the lacing at the back until the plate sits firmly at the front.

How tight should the straps be?

Tight enough that the plate does not tip when you move, but without cutting in. Tingling, numbness or red welts on legs and bottom mean: loosen at once. Check now and then how it feels, and say so if something presses.

How is it cleaned?

Wipe it with a damp cloth. You clean the plate and back panel with a damp cloth and a little mild soap. Take the rings out and wash them with warm water and soap. Then let everything air-dry before it goes back into the drawer.