Strap-on Hidden Desire Inferno Penis Sleeve Natural 18 x Ø 4 cm

Strap-on Hidden Desire Inferno Penis Sleeve Natural 18 x Ø 4 cm 🔗

The Inferno from Hidden Desire is a hollow silicone strap-on that is pulled over your own penis. The shaft is shaped true to life, with a glans and hinted veins, and curves slightly upwards. At the end sits a wide base with the opening for the penis, two side slots for the straps and an open bar on the underside. Everything is held by a harness: the hip strap has a wider back section, plus a narrow strap that runs between the buttocks. Both straps are adjustable. The sleeve has no motor, so it stays light and can be washed without worrying about electronics. It stands with the penile enlargement, under strap-ons and in the brand world of Hidden Desire.

✨ At a glance

• 🏷️ Manufacturer: Hidden Desire
• 🧵 Material: Silicone
• 🎨 Colour: Natural
• 📏 Measurements: 18 x Ø 4 cm
• 📐 Inner length: 12.5 cm
• 🛠️ Design: Hollow, with harness, no motor
• ✅ Strap length: 73 to 166 cm, adjustable
• ⚠️ Caution: Straps must not cut in

❓ FAQ

Who is a hollow sleeve meant for?

For wearers with a penis. Your own penis lies in the cavity, and the silicone shaft does the rest. If you have nothing to put inside, choose a solid model, see strap-ons.

How is it put on?

First guide the penis into the cavity, then close the hip strap, adjust the rear strap and tighten everything last. The straps should sit firmly but must not cut in: a finger has to fit between strap and skin. If you feel numbness, tingling or pressure pain, take the sleeve off at once. Try putting it on once in peace before it matters.

What applies during penetration?

Use plenty of water-based lubricant, because silicone-based lubricant attacks the surface, see water-based lubricant. Start slowly and match the pace to your partner. In anal play the wide base stays outside and acts as a stop; go especially gently here.

How is it cleaned?

Sleeve and harness separately: wash the sleeve inside and out with lukewarm water and toy cleaner, and only wipe the harness with a damp cloth. Then let the cavity dry completely with the opening facing down before you put the sleeve away; otherwise moisture stays inside.