Harness Strap U Bodice Corset Style with Lacing Leather Black 10.2 cm

Harness Strap U Bodice Corset Style with Lacing Leather Black 10.2 cm 🎀

The Strap U Bodice is a strap-on harness of black leather whose wide back section laces up like a corset. A cord runs through metal eyelets there and draws the waistband tighter or looser; a D-ring sits on either side of the lacing. At the sides the waistband also has a buckle each, which adjusts it further. At the front a triangular leather panel holds the metal O-ring, and two narrow leg straps lead from there between the legs to the back. A dildo is not included. From the Strap U range by XR Brands. It stands under strap-ons, with sex toys for couples and under sextoys for women; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: leather and steel
• 📏 Length: 10.2 cm
• 🎨 Colour: black
• 🎀 Back: corset lacing with two D-rings
• 🔒 Closure: two side buckles
• ✅ Takes: metal O-ring
• ✅ Leg straps: two
• 📦 Included: harness without a dildo
• 🪜 Range: Strap U

❓ FAQ

Which dildos fit the harness?

Only dildos with a pronounced base. The base has to be wider than the opening of the O-ring so that it rests against it from the inside and the shaft does not slip forward when thrusting. Without a suitable base the ring holds nothing.

How do you set the lacing?

Most easily before putting it on. Pull the cord roughly to your size, knot it and set the exact fit afterwards with the two side buckles. That way the lacing stays set for next time, and you only open the buckles to put it on and take it off.

How tight may it sit?

Tight enough that the dildo does not tilt, but without cutting in. A finger should fit under every strap. If the leg straps press into the groin or the skin tingles, loosen them; at numbness or deep marks the harness comes off.

How do you care for the leather?

With a damp cloth, never in a basin of water. Wipe off lubricant and sweat after every wear and let the leather dry in the air, not on the radiator. The metal parts take warm water with mild soap; store the harness flat and dry.