Masturbator Mila Buttocks with Vagina and Anus Remote Control Natural

Masturbator Mila Buttocks with Vagina and Anus Remote Control Natural 🍑

Mila by Crazy Bull shows a woman’s bottom with a section of back on which a line along the spine and two slight dimples are visible. The buttocks are round and compact, and the thighs end just below them. Low in the cleft a vagina with delicate labia opens, with the anus a little higher. Behind each opening lies its own channel, whose interior is made up of a series of small chambers with nubs and ribs. On the flat-cut waist sit two holes into which you insert the vibrating egg. The egg is permanently connected by a cable to the remote control, and with the dial on top you set the vibration from gentle to strong. The remote works with two AA batteries. Mila is made of soft TPE in a natural skin tone. It sits under masturbators, under sex toys for men and in our sex toys section. You will find more lifelike models under realistic masturbators.

✨ At a glance

• 🧵 Material: TPE
• 🎨 Colour: Natural
• 📏 Dimensions: 18 x 13.5 x 12.8 cm
• 🍑 Shape: bottom with vagina and anus, two chambered channels
• 📳 Vibration: vibrating egg on a corded remote, 2 x AA
• 👉 Use: water-based lubricant only
• ✅ Care: porous material, for one person only

❓ FAQ

Which lubricant do I use?

A water-based lubricant. Silicone-based lubes, oils and greasy creams break down the surface of TPE and make it greasy. You will find suitable products under water-based lubricant.

How do I clean Mila after use?

The vibrating egg comes out first, so that no water reaches the egg, cable or remote. Then rinse both channels with lukewarm water and a little sex toy cleaner. Let the bottom air-dry openly until it is completely dry inside the chambers too.

Why should only one person use it?

TPE has a porous structure. What settles in the pores cannot be removed completely, so you do not pass it on.

Can I warm Mila up?

Yes, without the egg: a few minutes in warm water is enough, then dry the outside. Microwave or radiator are out of the question, because too much heat deforms the TPE.