Nipple Pump Master Series 3-Way Suck Her Pump System for Nipples and Clitoris Red 21.5 cm

Nipple Pump Master Series 3-Way Suck Her Pump System for Nipples and Clitoris Red 21.5 cm 🎈

The 3-Way Suck Her nipple pump from the Master Series by XR Brands is a pump system for three spots at once: both nipples and the clitoris. Three clear cylinders in two sizes hang on red tubes from one shared pump; white connectors split the tube. The pump has a pistol grip with a trigger that you operate with one hand. A valve sits on top of each cylinder, through which the suction can be released again. Through the clear cylinders you can see at any time how the skin reacts. It stands under nipple clamps, with sextoys for women and under fetish sex toys; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: plastic, silicone tubes
• 📏 Length: 21.5 cm
• 🎨 Colour: red
• 🫙 Cylinders: three, clear, in two sizes
• 🎛️ Operation: pistol grip with trigger
• ✅ Valves: one on each cylinder
• 🪜 Range: Master Series
• ⚠️ Caution: pump slowly, only briefly, not on injured skin

❓ FAQ

How do you put the cylinders on?

On clean, dry skin. A little water-based lubricant on the cylinder rim seals better. You place each cylinder centrally and only start pumping once all three are in place.

What do you watch out for when pumping?

Start slowly and with little suction. Pull the trigger only a few times and build up gradually. If it hurts, the skin goes numb or turns dark, release the suction at once via the valves. You do not put the cylinders on injured or irritated skin.

How long may the suction work?

Briefly, only a few minutes at first. Then let the air in completely and give the skin a break before you start again. More time brings no better result, only pressure marks.

How do you take the cylinders off?

Let air in first, then take them off. Open the valve until the cylinder sits loosely and remove the cylinders one at a time and slowly. A cylinder is never pulled while under suction.

How do you clean the system?

Wash the cylinders, wipe the pump. Take the cylinders off the tubes and rinse them after every use with warm water and mild soap. Only wipe the pump and tubes on the outside with a damp cloth so that no water gets into the pump, and let everything air dry.