Nipple Suckers Master Series Black Max 2 Pieces Black

Nipple Suckers Master Series Black Max 2 Pieces Black 🔩

The Black Max from the Master Series by XR Brands are two nipple suckers with a twist mechanism. Each consists of a clear cylinder with a wide rim and a large black twist cap with deep finger grips. Inside runs a threaded rod with a piston and a dark sealing disc at its lower end. If you turn the cap clockwise, the piston moves up and builds a vacuum in the cylinder. You need no pump, hose or bulb for this. They stand under nipple clamps, with sextoys for women and under fetish sex toys; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: plastic
• 📏 Height: 19.5 cm
• 🎨 Colour: black
• 🔢 Contents: two suckers
• 🎛️ Operation: twist cap with threaded rod and piston
• 👁️ Cylinder: clear
• ⚖️ Weight: 197 g
• 🪜 Range: Master Series
• ⚠️ Caution: only briefly, release at once if it hurts

❓ FAQ

How do you put them on?

With the piston right at the bottom. Turn the cap all the way back first, place the rim of the cylinder flat around the nipple and press it on lightly so that it seals all round. Only then do you start turning, holding the cylinder steady with your other hand.

What does the clear cylinder offer?

You can see what happens inside. How far the nipple is drawn in and how the skin looks is in front of your eyes the whole time, and you do not have to rely on feel alone.

How do you take them off again?

By turning back. Turn the cap anticlockwise until the piston sits at the bottom again and no suction can be felt; the cylinder then comes away by itself. Never pull it off while it is still sucking.

How long may the suckers stay on?

Only briefly, a few minutes at a time. Build up the vacuum slowly, with small turns and pauses in between, and do not put the suckers on injured or irritated skin. In case of pain, numbness, discolouration or blisters, turn the cap back at once and take the sucker off.

How do you clean them?

With warm water and mild soap. Rinse the cylinders out thoroughly from below, wipe rim and sealing disc and let everything air dry before you put the suckers away.