Penis Pump Basic 1 Water-Resistant Transparent 20 x 6.5 cm

Penis Pump Basic 1 Water-Resistant Transparent 20 x 6.5 cm 🔎

Crystal clear and without any tint, the cylinder of the Basic 1 penis pump from Pumped shows everything that happens inside it. As a print it carries three nested arches in shades of grey, with rows of small grip ridges on the sides. A black coiled tube leads from its tip to a black hand bulb with a grid texture, and a valve sits just above the bulb. A black sleeve frames the rim of the opening. Because the pump works by hand, there is nothing to charge. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pumped.

✨ At a glance

• 🧵 Material: silicone and ABS
• 🎨 Colour: transparent, grey print
• 📏 Cylinder: 20 x 6.5 cm
• 🖐️ Pump: hand bulb on a coiled tube
• 🔓 Valve: just above the bulb
• 🔋 Power: none, purely mechanical
• 💧 Water protection: water-resistant
• ⚠️ Caution: start slowly, hold the suction only briefly

❓ FAQ

What does a session look like?

A little water-based lubricant on the sleeve, then place the cylinder until its rim touches the skin all round. Then pump with the bulb in small steps and keep an eye on what is happening through the clear wall. At the end the valve lets the air in, and the cylinder comes loose.

What do you have to stick to?

A slow pace and short times: the vacuum only lasts a few minutes, then you release it and pause. As soon as it hurts, feels numb, the skin changes colour or blisters appear, stop at once: open the valve. Sore or irritated skin is not pumped, and the testicles never go into the cylinder with it.

Does a cock ring go with it?

Yes, provided you wear it for 20 to 30 minutes at most after pumping. If you take blood thinners or have circulation problems, talk to a doctor first. Numb, cold, discoloured or painful? Then off it comes at once, and never fall asleep with a ring on.

How do you keep it clean?

The cylinder and the sleeve, which pulls off, can take warm water with mild soap. A damp cloth will do for the bulb and tube. It only goes back together once every part is completely dry.

Can it take water?

Every part shrugs off splashes and rinsing after use. This pump has no electronics that would need protecting.