Penis Pump Basic 1 Water-Resistant Yellow 20 x 6.5 cm

Penis Pump Basic 1 Water-Resistant Yellow 20 x 6.5 cm 💛

The cylinder of the Basic 1 penis pump from Pumped glows a light, translucent yellow, with three nested arches in a darker shade of yellow printed on it. Rows of small ribs run along the sides as grip zones. Pumping is done by hand: a black bulb with a grid texture hangs at the end of a coiled tube that leads into the tip of the cylinder. A small valve is fitted above the bulb. There is no motor or battery, and all parts are water-resistant. At the opening a black sleeve forms the seal against the skin. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pumped.

✨ At a glance

• 🧵 Material: silicone and ABS
• 🎨 Colour: yellow, translucent
• 📏 Cylinder: 20 x 6.5 cm
• ⚫ Bulb: black, with a grid texture
• 🔓 Valve: above the bulb
• 🔋 Power: none, purely mechanical
• 💧 Water protection: water-resistant

❓ FAQ

How finely can the pressure be dosed?

Very finely, because a single squeeze of the bulb only draws off a small amount of air. After each squeeze you can pause and feel whether it still feels good before you carry on.

What do you do if it becomes uncomfortable?

You open the valve at once. That applies with pain, with numbness, if the skin turns dark or blisters appear. As a rule you build the suction only slowly and release it again after a few minutes. When putting it on, make sure the testicles stay outside; if the skin is injured or irritated, the pump stays in the cupboard.

Can you put on a cock ring afterwards?

Yes, as long as it stays on for no longer than 20 to 30 minutes. If you take blood thinners or have circulation problems, talk to a doctor first. If it feels numb or cold, the skin changes colour or it hurts, you take it off at once, and nobody falls asleep with it on.

Why does the vacuum not hold?

Usually the sleeve is not sealing properly. Hair at the base lets air through; trimmed short, it lets the sleeve seal better, and a little water-based lubricant on the rim closes the last gaps. Also check that the valve is fully closed and the tube is pushed on firmly.

What care does it need, and where does it go?

After use the sleeve comes off, it and the cylinder are washed out with warm soapy water, and the bulb and tube are only wiped on the outside. Only once everything is dry do you put the parts back together and put the pump away somewhere dark and protected from dust.