Penis Pump Basic 2 Water-Resistant Black 20 x 6.5 cm

Penis Pump Basic 2 Water-Resistant Black 20 x 6.5 cm ⚫

A smoky dark cylinder with a black grip - the most discreet version in the Basic line. Basic 2 differs from Basic 1 in exactly one point: instead of a hand bulb on a tube, a trigger grip sits directly on the cylinder. Nothing dangles, one hand stays free, and it is pulled with two fingers. The vacuum is the same. Twenty centimetres of cylinder and six and a half across are the standard size of the line. Ten to fifteen minutes is enough. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pumped.

✨ At a glance

• 🧵 Material: silicone and ABS
• 🎨 Colour: Black
• ✅ Cylinder: 20 x 6.5 cm
• 📳 Drive: trigger grip on the cylinder
• ✅ Power: none needed
• ✅ Line: Basic 2
• ✅ Duration: ten to fifteen minutes

❓ FAQ

Bulb or trigger grip?

The grip sits firmly on the cylinder, the bulb hangs on a tube. With the grip one hand stays free and nothing dangles; the bulb can be squeezed in smaller steps. Both build the same vacuum.

Does the cylinder take knocks?

Yes, but it is not a tool. The plastic copes with everyday life in a drawer; a fall onto tiles can chip it, and a chipped cylinder should be replaced rather than kept in use.

How does a pump actually work?

It draws air out of the cylinder. The vacuum lets more blood flow in, and that is visible for as long as it is used. It does not create a permanent increase - nor does Pumped claim anywhere that it does.

How long may it be pumped?

Ten to fifteen minutes at a time, no longer. Release the pressure in between. Going beyond that risks bruises and burst capillaries rather than a better result.

How do you notice the pressure is too high?

By numbness, tingling or a dark discolouration. Open the valve at once. Pain is not a sign of effect but the signal to stop.

What does the sleeve do?

It seals. Without a clean seal against the body no vacuum builds up - the most common reason a pump appears not to work. Shaved skin seals better, and a drop of lubricant on the rim helps - suitable ones stand under water-based lubricant.

How is it cleaned?

Cylinder with warm water and soap, sleeve separately. The pump unit and anything holding electronics never goes under a running tap. Let it dry before the parts go back together.

How discreetly does it arrive?

In a plain box with no hint of the contents. The sender line says nothing that would tell the neighbours anything.