Penis Pump Basic 2 Water-Resistant Orange 20 x 6.5 cm

Penis Pump Basic 2 Water-Resistant Orange 20 x 6.5 cm 🧡

The cylinder of the Basic 2 penis pump from Pumped is orange and lets the light through, printed with three arches in a deeper orange. Two strips of ribs run along its sides. From the upper end a black coiled tube leads to a trigger grip operated by two fingers, and a valve between the two releases the air again. The rim of the opening is formed by a soft sleeve in black. The pump needs no power, and it is water-resistant as well. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pumped.

✨ At a glance

• 🧵 Material: silicone and ABS
• 🎨 Colour: orange, translucent
• 📏 Cylinder: 20 x 6.5 cm
• ✋ Grip zones: ribs on both sides
• 🔫 Pump: trigger grip with valve
• 💧 Water protection: water-resistant, no power needed
• ⚠️ Caution: pump gently, hold the suction only briefly

❓ FAQ

How does a session go?

First a little water-based lubricant on the rim of the sleeve, then put the cylinder on and pump with calm pulls on the grip. When it is enough, the valve releases the air and the cylinder lets go.

What is key to safety?

Increasing slowly and keeping it short at a few minutes, then letting the air out and taking a break. Pain, numbness, discolouration or blisters mean releasing at once. The scrotum stays outside when you put it on, and an injured or irritated spot is a clear no.

Is a cock ring fine once you have pumped?

Yes, provided the wearing time stays within 20 to 30 minutes. If you take blood thinners or have circulation problems, talk to a doctor first. If the skin or penis goes numb or cold, something changes colour or it hurts, you take it off at once. Nobody ever sleeps with a ring on.

What are the ribs on the cylinder for?

They give your hand a grippy surface, even when everything is a little slippery. That keeps the cylinder steady while the other hand pulls the trigger.

What does cleaning involve?

The removed sleeve and the cylinder go into warm soapy water, while the grip and tube get a damp cloth. Everything is dried thoroughly before you put the parts back together.