Penis Pump Ouch Elite with Gauge 21 x 6.5 cm

Penis Pump Ouch Elite with Gauge 21 x 6.5 cm 🎯

The Elite penis pump by Ouch! is operated with a pistol grip and shows the vacuum on a pressure gauge. The clear cylinder carries a printed scale, and at its opening sits a soft, neon green silicone ring that seals against the skin. The grip with its trigger sits on the side of the cylinder, above it the round gauge with a needle, and a neon green hose runs to the tip of the cylinder. Each pull of the trigger draws out a little air. Grip, hose and ring glow on in the dark once they have lain in the light for a while. It stands under pumps, with sex toys for men and under sex toys for beginners; what else comes from this brand is shown by the brand world of Ouch.

✨ At a glance

• 🧵 Material: ABS, silicone
• 🎨 Colour: green, cylinder transparent
• 💡 Extra: glow in the dark
• 📳 Drive: pistol grip with trigger
• 🎯 Display: pressure gauge with needle
• 📏 Size: 21 x Ø 6.5 cm
• ⚠️ Caution: build up the vacuum slowly, hold it only briefly

❓ FAQ

How do you use the pump?

Put a little water-based lubricant on the silicone ring and place the cylinder over the penis until the ring seals against the skin all round. Then pull the trigger at a steady pace while keeping an eye on skin and needle. Before you take the cylinder off, let all the air out.

What is the gauge for?

If you remember a value that felt good, you can find it again next time. There is no value you are meant to reach; the display is only for orientation, and how your body feels always comes first.

What do you watch for in terms of safety?

Build up the vacuum slowly and hold it for only a few minutes, then let the air out and take a break. At pain, numbness, dark discolouration or blisters, let the air out at once. The testicles stay outside the cylinder, and you never pump on injured or irritated skin. Pumping does not bring a permanent enlargement. If you put on a cock ring afterwards, wear it for no more than 20 to 30 minutes, take it off at once at numbness, coldness, discolouration or pain and never fall asleep with it.

How do you clean and store it?

Take off the ring, wash cylinder and ring with warm water and mild soap and let both dry completely. Only wipe grip, gauge and hose on the outside with a damp cloth; no water may get inside. Store the pump dry and free of dust, without pressure on cylinder or gauge.