Penis Pump RX3 Black 23 x 5.5 cm

Penis Pump RX3 Black 23 x 5.5 cm ⚫

The RX3 from Pump Addicted is a hand pump with a bulb. Its smoky black tinted cylinder tapers to a cone at the top, the hose attaches at the tip, and at its other end hangs a black bulb with a grid-like relief that gives grip when squeezing. Each squeeze takes out only a little air, so the suction can be dosed in small steps. The release valve sits where the hose meets the bulb. A fine scale runs along the cylinder, though it is subtle on the dark plastic. The pump is sold as the Power Pump RX-3. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pump Addicted.

✨ At a glance

• ✅ Type: penis pump with bulb
• 🧵 Material: ABS and silicone
• 🎨 Colour: black, tinted
• 📏 Dimensions: 23 x Ø 5.5 cm
• ✅ Cylinder: with scale
• ✅ Release valve: on the bulb
• ⚠️ Caution: only a few minutes at a time

❓ FAQ

How do you let the air out again?

With the valve on the bulb. The small valve between hose and bulb opens the way for the air, and the suction eases at once. Try the movement once without body contact so it comes naturally before it matters.

What is the RX3 made of?

The cylinder is hard ABS, the cuff at the opening soft silicone. It sits in a black ring at the lower end and settles against the skin without pinching.

How does the cylinder seal?

Through the cuff, which has to lie flat all the way round. Hair at the base of the penis lets air through; trimmed or shaved, the suction holds better. A drop of lubricant on the rim closes the last gaps; with silicone a water-based one is right, found under water-based lubricant.

How long may you pump?

Only a few minutes, then air out and a break. Build the vacuum slowly. Pain, numbness, discolouration or blisters are the signal to open the valve at once. The testicles stay outside the cylinder, and there is no pumping on injured or irritated skin.

How is the RX3 cleaned?

Cylinder and cuff with warm water and mild soap. Wipe the bulb and hose only on the outside with a damp cloth so that no water runs into the valve. Then let everything dry open.