Penis Pump RX5 Transparent 23 x 5.5 cm

Penis Pump RX5 Transparent 23 x 5.5 cm 🔎

A clear penis pump with a lever grip: on the transparent RX5 from Pump Addicted, the cylinder is crystal-clear ABS, the scale on it is easy to read, and everything that happens inside stays in view. Pumping is done with a black grip made of a curved bow and lever, which hangs from a hose at the conical tip of the cylinder. At the bottom sits a black ring with a soft silicone cuff. The pump is sold as the Power Pump RX-5. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pump Addicted.

✨ At a glance

• ✅ Type: penis pump with lever grip
• 🧵 Material: ABS and silicone
• 🎨 Colour: transparent
• 📏 Dimensions: 23 x Ø 5.5 cm
• 📳 Drive: lever grip
• ✅ Cylinder: clear, with scale
• ✅ Release valve: on the hose

❓ FAQ

How is the lever grip operated?

Bow in the palm, draw the lever in with the fingers. Each pull draws some air out of the cylinder while the other hand holds it in position.

Where do you let the air out again?

At the small valve below the grip. It sits on the hose, so you can reach it with the same hand that was just pumping. Try it once without body contact so the movement comes naturally.

Why is the clear cylinder practical?

You can see at any time what is happening in the cylinder. That way you notice early when a break is due and can adjust the suction accordingly.

Which safety rules apply?

Build up slowly, keep it short. After a few minutes the air comes out, then a break follows. With pain, numbness, discolouration or blisters, open the valve at once. The testicles stay outside the cylinder, and there is no pumping on injured or irritated skin.

How do you get the cuff to seal?

It needs skin contact all the way round. Hair kept short and a little lubricant on the rim help; a water-based one suits the silicone cuff, and a selection stands under water-based lubricant.

How is the pump cleaned?

Rinse cylinder and cuff with warm soapy water. Grip and hose stay dry and are only wiped so that no water gets into the valve. Then let everything dry open.