Penis Pump RX7 Transparent 24 x 6 cm

Penis Pump RX7 Transparent 24 x 6 cm 🔎

Clear cylinder, bow grip, soft cuff: the transparent RX7 from Pump Addicted shows everything that happens while pumping, and its scale is easy to read. At the top the cylinder tapers to a cone, from where a black hose leads to the grip. The grip consists of a rectangular frame with a T-shaped lever inside it. At the lower end sits a black ring with a soft silicone cuff. The pump is sold as the Power Pump RX-7. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pump Addicted.

✨ At a glance

• ✅ Type: penis pump with bow grip
• 🧵 Material: ABS and silicone
• 🎨 Colour: transparent
• 📏 Dimensions: 24 x Ø 6 cm
• 📳 Drive: bow grip
• ✅ Cylinder: clear, with scale
• ✅ Release valve: on the hose

❓ FAQ

How do you pump with the bow grip?

Take the frame in your hand and draw the lever in with your fingers. Each pull takes some air out of the cylinder; meanwhile the other hand holds it against the body.

Where is the air released?

At a small valve on the hose, just below the grip. When you open it, air flows back and the suction eases. Best practise it once before the pump sits on the body for the first time.

What does the clear cylinder show?

Everything that happens inside it. That way you notice in good time when a break is due and do not have to rely on your feeling alone.

What rules apply when pumping?

Build up slowly and keep it short. After a few minutes you let the air out and take a break. With pain, numbness, discolouration or blisters, open the valve at once. The testicles stay outside the cylinder, and irritated or injured skin is off limits.

How do you get the cuff to seal?

It needs skin contact all the way round. Hair kept short at the base of the penis and a little lubricant on the rim help; a water-based one suits the silicone cuff, and a selection stands under water-based lubricant.

How is the pump cleaned?

Rinse cylinder and cuff with warm soapy water. Only wipe grip and hose with a damp cloth so that no water gets into the valve. Then let it dry open.