Penis Pump RX9 with a Bullet Transparent 30 x 6 cm

Penis Pump RX9 with a Bullet Transparent 30 x 6 cm 🔎

The Penis Pump RX9 with a Bullet by Pump Addicted is the Power Pump RX-9 with a clear cylinder, together with the “Universal Sleeve & Vibrating Bullet” set. A round pressure gauge with a light dial sits on top of the flat black head. Through the see-through wall you keep the inside of the cylinder in view, and the scale next to it is easy to read. A black hose connects the head with the grip handle; a wide black ring forms the lower end. A bullet with a silver tip, set into a flexible band, adds the vibration. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pump Addicted.

✨ At a glance

• ✅ Type: penis pump with vibration accessory
• 🧵 Material: ABS and TPE
• 🎨 Colour: transparent
• 📏 Dimensions: 30 x 6 cm
• ✅ Display: gauge and scale
• ✅ Pump: grip handle, release valve
• 📳 Accessory: band with bullet and control unit
• ⚠️ Caution: build up the suction slowly

❓ FAQ

What is the gauge for?

It makes the vacuum visible. The needle reacts to every pull on the handle, so you can proceed deliberately in small steps. It is a guide and not a limit to push towards.

How does the vibration reach the pump?

Through the band on the outside of the cylinder. You wrap it around the wall; on one side it holds the bullet, on the other an elongated control unit. Inside everything stays clear, and without the accessory you simply keep pumping as normal.

What applies to duration and pressure?

A few minutes at a time and a calm build-up. Let some air out in between and start again. If pain, numbness, discolouration or blisters occur, open the valve at once. Do not draw the testicles into the cylinder, and do not put the pump on injured skin.

Why does the suction sometimes not build?

Because the ring is not sealing. It needs skin contact all the way round; a few hairs or a cylinder placed at an angle are enough to let air through. A little lubricant on the ring helps, and you will find suitable ones under water-based lubricant.

How do you clean the cylinder and the accessory?

The cylinder with warm water and mild soap, keeping the gauge dry. Take the band and the bullet off beforehand and only wipe them with a damp cloth. Afterwards everything dries in the air.