Penis Pump RX9 with Sleeve Transparent 30 x 6 cm

Penis Pump RX9 with Sleeve Transparent 30 x 6 cm 🔎

The Penis Pump RX9 with Sleeve by Pump Addicted brings together the Power Pump RX-9 with a clear cylinder and a Pleasure Sleeve in size M. A round pressure gauge sits on the flat black head, and below it the see-through cylinder with its scale begins. The hose leads from the head to the grip handle, and at the lower end a wide black ring frames the opening. The sleeve is made of soft TPE, has nubs and ribs inside and opens at the front in the shape of a vulva. Through the clear wall you can see how it sits in the cylinder. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pump Addicted.

✨ At a glance

• ✅ Type: penis pump with masturbator sleeve
• 🧵 Material: ABS and TPE
• 🎨 Colour: transparent
• 📏 Dimensions: 30 x 6 cm
• ✅ Display: gauge and scale
• ✅ Pump: grip handle, release valve
• ✅ Sleeve: Pleasure Sleeve, size M, textured inside
• ⚠️ Caution: release the air at once if it hurts

❓ FAQ

What does the sleeve add to the pump?

Friction and suction at the same time. Its narrow channel sits in the cylinder, while the wide collar stays at the opening. The vacuum draws the textured inner wall against the shaft, and the gauge keeps showing how strong the suction is. You can also guide the sleeve by hand without the pump.

How do you use the gauge?

As a guide, not as a target. The needle helps you increase carefully and in small steps. It does not set a safe maximum.

How long and how strongly do you pump?

Build up slowly and hold for only a few minutes. Let the air out between rounds. If you feel pain or numbness, or notice discolouration or blisters, open the release valve at once. The testicles stay outside the cylinder, and you do not pump on injured skin.

Which lubricant suits the sleeve and the ring?

A water-based one. It is suitable for the TPE of the sleeve and makes sure the ring seals all the way round. You will find a selection under water-based lubricant.

How does the set stay clean?

Rinse the sleeve, wash the cylinder. Flush the channel of the sleeve with warm water and let it dry completely. Clean the cylinder with mild soap without holding the gauge under water.