Penis Sleeve with Two Rings and Studs Grey

Penis Sleeve with Two Rings and Studs Grey 🩶

This short penis sleeve by Pretty Love is a thick-walled tube of smoky grey, translucent TPE, open at both ends. Several flat panels are set into the wall, carrying rows of small, round studs. A thick black ring frames one of the openings. A second, grey ring is moulded on below the other end, and you guide the scrotum through it. The sleeve therefore sits at the base of the shaft, leaving the glans and the upper shaft free. It stands under penile enlargement, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pretty Love.

✨ At a glance

• 🧵 Material: TPE
• 📏 Length: 7.2 cm
• 🛠️ Design: short tube, open at both ends
• ✋ Surface: panels with rows of studs
• ⭕ Rings: black rim at the front, moulded ring for the scrotum
• 🎨 Colour: Grey
• ⚠️ Caution: wear for no more than 20 to 30 minutes

❓ FAQ

How do you put it on?

Put a little lubricant into the tube and onto your penis. First guide the scrotum carefully through the grey ring, then slide the tube over the shaft up to the body. It is easiest while the penis is not yet fully erect.

How long may you wear it?

No more than 20 to 30 minutes at a time, because the loop sits tightly around the scrotum. Take it off at once if you notice numbness, coldness, discolouration or pain, and never fall asleep wearing it. If you take blood thinners, only use it after speaking to your doctor.

Does it add length?

No. It is open at the front and only encloses the lower part of the shaft, so it changes nothing about length. Your partner feels the black ring and the stud panels instead.

Is it a condom?

No. It protects neither against infections nor against becoming parents unintentionally. Before it passes to another person, clean it thoroughly.

Which lubricant suits it, and how do you care for TPE?

TPE is porous. That is why only water-based lubricant goes on it, never oil, petroleum jelly or silicone-based gel. After use, wash the sleeve inside and out with warm water and mild soap, on the stud panels and under the black ring too, and let it dry completely. Store it free of dust and apart from other toys, as TPE can take on colour from other materials.