Penis Sleeve Pleasure Sleeve Size L Transparent

Penis Sleeve Pleasure Sleeve Size L Transparent 🔎

The Pleasure Sleeve from Pump Addicted is a clear insert of soft TPE for the cylinder of a penis pump, here in size L. Towards the front it runs as a slim tube; at the open end it has a wide, round collar that reaches over the rim of the cylinder and seals it. Inside, a channel with nubs and ribs runs all the way to the back. As soon as the pump draws air out, the material settles against the penis, and suction and texture work at the same time. Without a pump, the sleeve can be guided by hand like a small masturbator. It stands under masturbators, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pump Addicted.

✨ At a glance

• ✅ Type: penis sleeve for penis pumps
• 🧵 Material: TPE
• 🎨 Colour: transparent
• 🪜 Size: L
• ✅ Inside: nubs and ribs
• ✅ Rim: wide, round collar
• 👉 Use: in the pump or by hand

❓ FAQ

How does the sleeve go into the pump?

Push it into the cylinder narrow end first. It sits correctly when the wide collar rests on the rim all the way round; only then can a vacuum build up when pumping.

Which size fits?

Girth decides, not length. The sleeve should fit snugly without constricting at the opening. L is the size for a fuller girth. If it is too tight, the collar presses at the base of the penis and sealing becomes uncomfortable.

Which lubricant suits TPE?

Water-based only. Silicone lubricant and oil attack the surface, which turns dull and sticky, and that cannot be undone. Suitable ones stand under water-based lubricant.

What applies when pumping with the sleeve?

Build the vacuum slowly and hold it for only a few minutes. With pain, numbness, discolouration or blisters, release the air at once. The testicles stay outside the cylinder, and there is no pumping on injured or irritated skin.

How is the sleeve cleaned?

Rinse the inside with warm water, wash the outside with soap. Then let it dry upside down and only put it away once nothing is damp; a touch of powder keeps the TPE from going tacky.