Penis Pump Basic 2 Water-Resistant Black 20 x 6.5 cm

Penis Pump Basic 2 Water-Resistant Black 20 x 6.5 cm ⚫

Black in every part: on the Basic 2 penis pump from Pumped the tube, trigger grip, valve and sleeve are black, and the cylinder is tinted dark too, while staying translucent like smoked glass. Three arches are printed on it that stand out only slightly from the base shade, and ribs run along the sides. To pump, you pull the trigger with two fingers, and the valve above the grip releases the air again. The pump never needs a socket and is water-resistant too. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pumped.

✨ At a glance

• 🧵 Material: silicone and ABS
• 🎨 Colour: black, smoky tint
• 📏 Cylinder: 20 x 6.5 cm
• 🔫 Pump: trigger grip on the tube
• 🔓 Valve: above the grip
• 💧 Water protection: water-resistant
• ⚠️ Caution: build slowly, hold briefly, take breaks

❓ FAQ

How much does the tinted cylinder let you see?

You make out contours and movement, but not fine details. How much shows through also depends on the light in the room.

How do you apply it?

A little water-based lubricant goes on the rim of the sleeve, then you place the cylinder and pump pull by pull. Take your time between pulls so that you notice when it is enough.

What applies to safety?

Give the suction time to build, and release it again after a few minutes before a break follows. Without hesitating you open the valve if it hurts, goes numb, the skin changes colour or blisters form. Do not draw any of the scrotum in when you put it on, and take a break from pumping if the skin is injured or irritated.

Is a cock ring an option afterwards?

Yes, and its wearing time then ends after 20 to 30 minutes at the latest. If you take blood thinners or have circulation problems, talk to a doctor first. It comes off at once if coldness, numbness, discolouration or pain sets in, and before falling asleep in any case.

What do you do after pumping?

Clean it after every use: off with the sleeve, then mild soap and warm water for the sleeve and cylinder, and a damp wipe for the outside of the grip and tube. Once everything is dry, you put the pump away protected from dust and without a kink in the tube.