Penis Pump Basic 2 Water-Resistant Transparent 20 x 6.5 cm

Penis Pump Basic 2 Water-Resistant Transparent 20 x 6.5 cm 🔎

The Basic 2 penis pump from Pumped works entirely without a motor or battery. Its clear cylinder carries a printed scale on the side and has a connector for the black hose at the top. At the lower end a black silicone sleeve closes off the opening towards the body. The pump grip hangs at the other end of the hose, a frame with a T-shaped trigger inside. The release valve sits directly above the grip. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pumped.

✨ At a glance

• 🧵 Material: silicone and ABS
• 🎨 Colour: Transparent
• 📏 Cylinder: 20 x 6.5 cm
• 🖐️ Pump: frame grip with T-trigger on the hose
• 🔓 Release: valve above the grip
• 📐 Scale: printed on the cylinder
• 💧 Water protection: water-resistant
• ⚠️ Caution: hold the vacuum for a few minutes only

❓ FAQ

How do you build up the vacuum?

In short pulls with pauses in between. Hold the cylinder flat against your body with the sleeve, take the frame in your other hand and pull the trigger with two fingers. Let go and pull again; the suction rises in small steps, and after each pull you can tell whether it still feels good. The valve lets air back in at any time.

What do you need to watch while pumping?

Increase slowly and hold the suction only briefly. After a few minutes you let the air out and take a break. Pain, numbness, a dark discolouration or blisters mean: open the valve at once. The testicles stay outside the cylinder, and you never pump on irritated or injured skin.

How does the sleeve seal?

Smooth skin and a touch of lubricant help. If the sleeve does not sit flush all round, the cylinder draws in air from outside and the suction does not build. Trimmed or shaved hair at the base improves the seal, as does a little lubricant on the rim. Suitable ones are under water-based lubricant.

How do you clean the Basic 2?

Cylinder and sleeve separately with warm water and mild soap. Rinse thoroughly and let them air-dry before you put the parts back together. Wipe the grip, valve and hose with a damp cloth. Store the pump dry and so that the hose does not kink.

Can you wear a cock ring afterwards?

Yes, but only for a limited time. Wear it for 20 to 30 minutes at most. If you take blood thinners or have circulation problems, talk to a doctor first. If the penis feels numb or cold, the skin changes colour or it hurts, take it off immediately. Never fall asleep with a ring on.