Penis Pump Beginner's Vibrating Pump Clear 18 x 5 cm

Penis Pump Beginner's Vibrating Pump Clear 18 x 5 cm 📳

The Penis Pump Beginner's Vibrating Pump by Pump Worx combines a bulb pump with a vibration unit. Its cylinder is see-through and framed by a black ring at the bottom; via a black hose it is connected to a pump bulb with a grid pattern and a cross-piece with a button on the side. An elastic black strap runs around the middle of the cylinder. On one side it holds a bullet that is linked by a cable to the control unit. An arc from “OFF” to “S” is printed on the control unit, and a small wheel sits on its side. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pump Worx.

✨ At a glance

• ✅ Type: penis pump with vibration
• 🧵 Material: PVC
• 🎨 Colour: transparent
• 📏 Dimensions: 18 x 5 cm
• ✅ Pump: bulb with valve
• 📳 Vibration: bullet with control unit on the strap, removable
• ⚠️ Caution: release the air at once if you feel numb

❓ FAQ

How does the vibration get into the pump?

From the outside through the cylinder wall. The bullet sits in the strap and passes its vibration on to the cylinder, while the inside stays clear. The unit can be removed, so you can also pump without vibration.

How do you use the bulb pump?

With short squeezes of the bulb. Each squeeze takes a little air out of the cylinder, and between squeezes you check how strong the suction is. When you want to stop, the valve lets the air back in all at once.

What applies to safety when pumping?

Increase slowly and hold for only a few minutes. If pain, numbness, discolouration or blisters appear, open the valve at once. The testicles stay outside the cylinder, and you do not pump on injured skin.

How does the pump seal?

With the black ring at the lower end. It has to lie flat on the skin all the way round, otherwise the pump draws in air from the side. Short hair and a drop of lubricant on the ring help, and you will find suitable ones under water-based lubricant.

How do you clean the pump?

The cylinder with warm water and mild soap. Remove the vibration unit beforehand, because it must not go into water; only wipe the strap, bullet and control unit with a damp cloth. Afterwards everything dries in the open air.