Urethral Sound Master Series Mortal Coil Stainless Steel with Beads and a Ring Silver 12 cm

Urethral Sound Master Series Mortal Coil Stainless Steel with Beads and a Ring Silver 12 cm ⚙️

The Mortal Coil from the Master Series by XR Brands is a urethral sound made of polished stainless steel. Its shaft is a chain of elongated beads that start narrow at the rounded tip and become a little wider towards the top. It ends in a smooth cylinder from which a metal ring hangs on a small eyelet. This ring stays outside, serves as your grip for pulling it out and prevents the sound from disappearing completely into the urethra. It stands under urethral toys, with sex toys for men and under fetish sex toys; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: stainless steel, polished
• 📏 Length: 12 cm
• 🎨 Colour: silver
• 〰️ Shaft: chain of beads, widening towards the top
• ⭕ End: metal ring as grip and stop
• ✅ Care: boilable
• ⚠️ Caution: only cleaned, with sterile lubricant and without force
• 🪜 Range: Master Series

❓ FAQ

How do I prepare the sound?

Thoroughly cleaned and disinfected. Stainless steel tolerates boiling water, so you can boil the sound for a few minutes or wipe it with a disinfectant. Wash your hands first and lay it on a clean surface until you use it.

Which lubricant suits it?

Only a sterile water-based lubricant. The safest choice is a freshly opened single portion, because a tube that has been lying open for a while is no longer germ-free. You will find a selection under water-based lubricant.

How do I insert it correctly?

Without any pressure. Place the tip and let the sound slide down under its own weight only; you never push it further, even if a bead catches. If you feel pain or burning or see blood, stop at once. Without experience, start with the thinnest smooth sound you can get before reaching for a bead chain like this one.

What do the beads feel like?

Like individual steps. Each bead stretches briefly as it slides in and then eases off again, so you perceive the way in section by section rather than as even pressure. Because the beads widen towards the top, this stretch increases a little with every section.

How long does it stay in, and how does it come out?

Only briefly. To remove it, take hold of the ring and pull the sound out slowly and straight, without twisting it. Take it out in good time, before you get tired or could fall asleep. Afterwards wash it with warm water, let it dry completely and store it protected from dust in a pouch of its own.