DIY Dildo Penis Cloner Kit with Vibration Black

DIY Dildo Penis Cloner Kit with Vibration Black 🧪

With the Penis Cloner Kit with Vibration by Cloneboy you cast a vibrator modelled on your own penis. It works in two steps: first you take an impression in a mixture of impression powder and water, then you fill that impression with silicone. What decides success or failure is less dexterity than time. The powder sets within a few minutes, and the water temperature determines how fast: colder water buys more time, warmer less. So lay everything out and read through the steps calmly before you start mixing. The impression only works with a stable erection that lasts the full duration; that is where most attempts fail, and it is not a question of the kit. It is cast in black silicone. This version includes a vibration insert. The cup needs a place where it cannot tip over, the sink is best. Two people make it easier: one stirs, one holds. Trim your pubic hair beforehand or put cream on it, otherwise it stays in the mixture. The silicone hardens over hours, and anyone unmoulding too early ends up with a soft lump instead of a cast. It sits under penis casting kits, under sex toys and in our sex toys for couples section.

✨ At a glance

• 🧵 Material: Silicone
• 🎨 Colour: Black
• 👉 Use: Lay everything out first, cool water
• ✅ Care: Wash the finished silicone, let it dry
• ⭐ Special feature: With vibration

❓ FAQ

How often can a kit be used?

You cast once, the silicone is portioned for one cast. The impression powder is enough for two moulds, so if the first impression fails, you get a second attempt.

What is in the kit?

Among other things the impression powder, the silicone for casting, a wooden spatula for mixing, the vibration insert, a slim black stick vibrator, and an adjustable cock ring: a black loop with a sliding bead.

How long may the cock ring be worn?

Twenty to thirty minutes at a stretch at most. If anything hurts, turns cold or numb, or the skin changes colour, it comes off at once, sooner rather than later if in doubt. Take a break afterwards before putting it on again. Never fall asleep wearing it.

How does the vibration get into the cast?

The vibration insert is pushed into the finished, cured silicone. It is electronics: pull it out again before cleaning, only the silicone goes under water.

Which lubricant suits the finished cast?

A water-based one. Silicone lubricant attacks the silicone and makes the surface sticky over time.

Is the result true to the original?

Close, but not perfect: this is a cast from your own kitchen and not series production, so small bubbles and a not quite smooth surface are part of it. Anyone expecting a smooth, factory-made surface is better off under realistic dildos.